收藏本站
LTC3490
APPLICATIO S I FOR ATIO
The LTC3490 requires only four external components to
operate: an inductor, an output capacitor, a switch and a
pull-down resistor. The inductor is nominally set at 3.3 μ H
and the capacitor at 4.7 μ F. Optional components include
an input capacitor and dimming resistors.
COMPONENT SELECTION
Inductor Selection
The high frequency operation of the LTC3490 allows the
use of small surface mount inductors. The minimum
inductance value is proportional to the operating fre-
quency and is limited by the following constraints:
where:
V IN = Input Voltage (V)
V OUT = Output Voltage (V)
I OUT = LED Drive Current (A)
I IN = Input Current = V OUT /V IN ? I OUT (A)
R P = R DSON of the PFET Switch ( ? )
R N = R DSON of the NFET Switch ( ? )
For high efficiency, choose an inductor with a high fre-
quency core material, such as ferrite, to reduce core
losses. The inductor should have low ESR (equivalent
series resistance) to reduce the I 2 R losses and must be
L ≥ H
V IN ( MIN ) ? ( V OUT ( MAX ) – V IN ( MIN )
and
L ≥
3
f
f ? Ripple ? V OUT ( MAX )
) H
able to handle the peak inductor current at full load without
saturating. In single cell applications, the inductor ESR
must be below 25m ? to keep the efficiency up and
maintain output current regulation. Dual cell applications
can tolerate significantly higher ESR (up to 75m ? ) with
minimal efficiency degradation. Molded chokes or chip
inductors usually do not have enough core to support the
where:
f = Operating Frequency (Hz)
Ripple = Inductor Current Ripple (A)
V IN(MIN) = Minimum Input Voltage (V)
peak inductor currents in the 1A to 2A region. If radiated
noise is an issue, use a toroid, pot core or shielded bobbin
inductor to minimize radiated noise. See Table 1 for a list
of suggested inductors. Look closely at the manufacturers
data sheets; they specify saturation current differently.
Table 1. Inductor Information
V OUT(MAX) = Maximum Output Voltage (V)
The inductor current ripple is typically set to 20% to 40%
of the inductor current.
The peak inductor current is given by:
INDUCTOR PART NUMBER
TOKO A918CY-3R3M
TYCO DN4835-3R3M
TDK SLF7045T-3R3M2R5
ESR (m ? )
47
58
20
SATURATION CURRENT (A)
1.97
2.15
2.5
V IN ( V OUT – V IN )
I LPK = I OUT
( V OUT + I OUT ? R P ) – R N ? I IN
V IN – R N ? I IN
+
2 ? L ? f ? V OUT
Output Capacitor Selection
The output capacitor value and equivalent series resis-
tance (ESR) are the primary factors in the output ripple.
The output ripple is not a direct concern for LED drive as
the LED will operate at the average current value. However
the peak pulsed forward current rating of the LED must not
be exceeded to avoid damaging the LED.
3490fa
7
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTC3783EFE#PBF IC LED DRVR PWM CONTROL 16-TSSOP
LV5026MC-AH IC LED DRIVER 1CH HV 10SOIC
LV5213LP-TE-L-E IC LED DVR 3CH CELL PHONE VCT16
LV5216CS-TE-L-E IC LED DRIVER 10CH CELL 36WLP
LV5217GP-TE-L-E IC LED DVR 3CH CELL PHONE VCT16
LV8498CT-TE-L-H IC MOTOR DRIVER S111 WLP
LXC100-4200SW POWER SUPPLY LED 100W 4200MA
LXC120-4900SW POWER SUPPLY LED 120W 4900MA
相关代理商/技术参数
LTC3490EDD#TRPBF 功能描述:IC LED DRIVER PHOTO FLASH 8-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3490ES8 制造商:LINER 制造商全称:Linear Technology 功能描述:Single Cell 350mA LED Driver
LTC3490ES8#PBF 功能描述:IC LED DRIVER PHOTO FLASH 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:60 系列:- 恒定电流:- 恒定电压:- 拓扑:线性（LDO），PWM，升压（升压） 输出数:8 内部驱动器:是 类型 - 主要:背光 类型 - 次要:RGB，白色 LED 频率:500kHz ~ 1.5MHz 电源电压:4.75 V ~ 26 V 输出电压:45V 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* 工作温度:-40°C ~ 85°C
LTC3490ES8#TRPBF 功能描述:IC LED DRIVER PHOTO FLASH 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3499 制造商:LINER 制造商全称:Linear Technology 功能描述:750mA Synchronous Step-Up DC/DC Converters with Reverse-Battery Protection
LTC3499B 制造商:LINER 制造商全称:Linear Technology 功能描述:750mA Synchronous Step-Up DC/DC Converters with Reverse-Battery Protection
LTC3499BEDD 制造商:LINER 制造商全称:Linear Technology 功能描述:750mA Synchronous Step-Up DC/DC Converters with Reverse-Battery Protection
LTC3499BEDD#PBF 功能描述:IC REG BOOST SYNC ADJ 0.75A 8DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2